![]() Remove the top cap and bolt. Use a 5 mm Allen wrench to remove the bolt at the top of the steerer tube.Remove the deflopilator spring. Use an Allen wrench or screwdriver shaft, perpendicular to the spring, to leverage the spring off of one of the mounting point eyelets and set aside.Slide the brake cable up and out of the front fork cable guide.Loosen the barrel adjuster and slide the brake cable out of the caliper. If there is a cable crimp installed on the end of the cable, use wire cutters to snip off the crimp. Remove the brake cable from the caliper. Use a 5 mm Allen wrench to loosen the cable pinch bolt enough to allow the brake cable to slide out of the caliper arm. ![]() Use a 5 mm Allen wrench to loosen the two bolts holding the caliper to the fork lower and set aside. Remove the brake caliper from the front fork.Remove the front wheel. Open the quick release lever and remove the front wheel from the front fork dropouts.Pass the fender between the tire and fork to remove and set aside. Use a 4 mm Allen wrench or Phillips head screwdriver (depending on model year) to remove the bolts holding the fender mounting bracket to each side of the front fork lowers. Remove the headlight and front fender. Use a 4 mm Allen wrench to remove the bolt holding the headlight and top fender mount to the frame and set aside.Get the bike ready for maintenance. Turn off the bike, remove the battery, and press and hold MODE to discharge remaining power.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |